Replacement RCA Cable for Dual Turntables / Record Changers /

These custom made RCA cables fit Dual turntables that use part number #207-301. They're about 5' [153 cm] in length with four 2.8 mm spade connectors on one end and 2 RCA plugs on the other. We make these using Amazon Basics RCA cables which are some of the nicest we've found. They're well shielded, have a capacitance of < 23 pf per foot, and the cable itself is very flexible (unlike many other premium cables). The spade lugs are crimped and soldered. Because these cables are thicker than the originals we include a larger cable clamp and longer screw to replace the original metal clamp. We also supply a grommet & zip-tie to replace the second strain relief on some models. T he included instructions show a typical installation but each model & base combination will differ slightly so it's impossible to show every contingency. It's really a simple procedure and we don't want to make the job sound more complex than it is but it's up to you to make sure these will fit your model and that you're up to the task before ordering. If you have questions please ask us before placing your order. Note: These will NOT fit the CS-5000 and are not for models that use cables with RCA plugs on both ends. (I.E...1009, 1010, 1015, 1016, 1019, 1209, 1214, 1216, 1218, 1219, 1228, 1229, etc). These fit RCA jacks with spacings as close as 9/16 (14.2mm) center-to-center. In another listing we offer the identical cable with metal RCA plugs that have a slightly smaller barrel diameter in order to fit vintage receivers with very closely spaced or recessed RCA jacks. We also list this cable bundled with a ground wire. If your ground wire is missing or damaged ordering the bundle saves you the shipping cost of the ground wire. Thanks for looking!